Direct OEM Replacement MOMENTARY Push Switches
With Dual LED lights in BLUE

These 12 volt push switches from AOB are single throw MOMENTARY switches designed to operate your 12 volt accessories. They have a face surface size of 22 mm x 22 mm and use the original mounting hole of the vehicle.

These Switches are aftermarket switches that lock into your existing panel super easy to install in less than 10 min's.

• Single Pole Single Throw MOMENTARY PUSH switches
• Black hard surface
• Laser etched Legend
• Single upper L.E.D light in BLUE
• Single lower L.E.D light in BLUE
• Upper light is ON when the switch is pressed IN
• Lower light can be wired to separate dash light circuit
• Rated at 3Amp 12V
• Wire Plug and wiring diagram supplied with switch

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switches are electronic switches rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.

AOBSWT100 series

Rear picture showing terminals and wiring harness supplied with switch

Wiring diagram will be supplied with switch purchase.

AOBSWT100 series Illumination

When switch is turned on the top light illuminates.

The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice.

(this is a sample image with the LED LIGHT BAR logo)