Direct OEM Replacement ON-OFF Push Switch
With Dual LED lights

Small Square Push Latching type Switch Designed FOR:

Toyota LandCruiser 300s 2022 - Onwards

Hilux 2025 - Onwards

Toyota LandCruiser 70s

2024 - Onwards

Toyota Prado 150s

08/2017 - Onwards

Toyota Prado 250s

2024 - Onwards

Toyota RAV4 & RAV4 Hybrid

01/2019 - Onwards

Toyota Camry 70 Series

09/2017- Onwards

Toyota Hiace

02/2019 - Onwards

Toyota Corolla

06/2018 - Onwards

Please check the hole size before purchase

This 12 volt push switch from AOB is a single throw ON - OFF switch designed to operate your 12 volt accessories. It has a face surface size of 22 mm x 22 mm and uses the original mounting hole of the vehicle.

This Switch is an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's.

• Single Pole Single Throw ON - OFF PUSH switch
• Black hard surface
• Laser etched Legend
• Single upper L.E.D light in BLUE
• Single lower L.E.D light in BLUE
• Upper light is ON when the switch is pressed IN
• Lower light can be wired to separate dash light circuit
• Rated at 3Amp 12V
• Wire Plug and wiring diagram supplied with switch

All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.

The switch is an electronic switch rated at 3amp's. Therefore in ALL cases the accessory MUST be wired through a fused relay.

AOBSWT100 series

Rear picture showing terminals and wiring harness supplied with switch

Wiring diagram will be supplied with switch purchase.

AOBSWT100 series Illumination | When switch is turned on the top light illuminates.

The bottom Etching (words) has an Independent wiring circuit to connect to your dash lights. You can connect it to the dash light circuit or leave off, your choice. (this is a sample image with the LED LIGHT BAR logo)